Enabling The "Enter" Key; Setting The Priority; Technical Setting Parameters; Enabling Use Of The Hand Sensor - Technogym Top 600 XTPRO Service Maintenance Manual

Standard / ifi
Table of Contents

Advertisement

TOP 600 XTPRO: Service & Maintenance Manual - rev. 2.0
9.1.6.
E
NABLING THE
The "ENTER" key can be enabled to increase the amount of exercising time during manual and
CPR training sessions. To change the current setting, when the setting is actually in use will scroll
on the LED matrix:
press the proper numeric key (1 or 2) to choose the desired setting, as for the following table:
and press ENTER to confirm your choice.
9.1.7.
S
ETTING THE PRIORITY
For cases where both the chest band and hand sensor are present, it is possible to configure which
one should be the priority source for the heart rate display. Obviously, if there is a signal available
from only one of the 2 sources, it will be used even if it has not been configured as the priority
source. To change this setting, when the LED display is showing the current priority value, press
the number keys (from 1 to 2) to set the desired priority as shown in the following table:
then press ENTER to confirm the changes made.
The system will now go back to the standby mode. The "CLEAR" key can be pressed at any time to
interrupt the setup procedure and return the equipment to the standby mode.

9.2. TECHNICAL SETTING PARAMETERS

To change the settings of the machine, when the equipment is in the standby mode, press numeric
keys 314 at the same time. The following will appear on the LED matrix:
Now, use the numeric keys to enter 2501 (the password) and press ENTER to confirm. At this
point, the setting procedure will show on the LED matrix the actual settings.
9.2.1.
E
NABLING USE OF THE HAND SENSOR
It is possible to enable the use of the sensors acquisition of the heart rate. To change this setting,
when the LED display is showing the current configuration, press the number keys (from 1 to 2) to
enable or disable the hand sensor, as indicated in the table below:
"ENTER"
KEY
ENTER TO INCREASE TIME = xxx
K
"E
EY
NTER
1
OFF = DISABLED
2
ON = ENABLED
K
P
EY
RIORITY
1
CHEST BAND PRIORITY
2
HEART SENSOR PRIORITY
PASSWORD = 0
K
H
EY
EART SENSOR
"
KEY
Page 9.3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents