Dismantling The Brake And The Flywheel Unit - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

7.11. DISMANTLING THE BRAKE AND THE FLYWHEEL UNIT

Figure 7.11-1
Figure 7.11-2
Page 7.28
Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
Carry out the operations in the paragraph: 7.1.
"IMPORTANT NOTE ON DISMANTLING" and
7.7. "Dismantling the guard".
1. Disconnect the two fastons on the brake
winding, as highlighted in the figure at the
side.
2. Unscrew the 2 stop screws (a) using a 4mm
Allen wrench.
3. Remove the brake unit (b) with care.
4. Unscrew the flywheel unit (a) from the
central shaft, using a 6mm Allen wrench,
while blocking it on the opposite side using a
10mm Allen wrench.
5. With care, remove the flywheel unit from the
side opposite the speed sensor.
DANGER: Pay particular attention to
the copper disk as it could easily
buckle.
WARNING: During
tighten the screws (a) using a torque
wrench set at 5Nm.
WARNING: After
flywheel unit, use a comparator to
check for any buckling on the copper
disk with a margin of ± 0.15mm.
WARNING: During
tighten the flywheel using a torque
wrench set at 25Nm.
Continues on the next page...
re-assembly,
re-fitting the
re-assembly,