19-Inch Rack Mounting Installation - NEC NEAX2000 IVS2 Installation Manual

19-Inch Rack Mounting Installation

START
CHECKUP BEFORE
INSTALLATION
DETACHING SIDE
COVER/SIDE PANEL
ONE PIM
CONFIGURATION
MULTIPLE-PIM
CONFIGURATION
CHECKING
END
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 3.0
• Check the site for installing the PBX with the work drawing to verify that
the required floor space is ensured and that service entrances and ducts
for trunk/extension cables, power cables and grounding conductors
have been properly worked at correct positions.
See Figure 2-7 and
• Detach the SIDE COVER and SIDE PANEL of the Module for 19-inch
RACK BRACKET (A) mounting. For 19-inch RACK BRACKET (B), this
procedure is not required. See "Detaching SIDE COVER/SIDE PANEL-
inch on "Detaching SIDE COVER/SIDE
• Mount the 19-inch RACK BRACKET (A) to the PIM. See
19-inch RACK BRACKET
• Mount the PIM with the 19-inch RACK BRACKET (A) to the 19-inch
RACK. See "Mounting PIM to 19-Inch
• Mount the 19-inch RACK BRACKET (B) to the bottom-stack PIM. See
"Connection of 19-inch RACK BRACKET
• Mount the 19-inch RACK BRACKET (A) to the top-stack PIM. See
"Connection of 19-Inch RACK BRACKET
• Mount the PIMs with the 19-inch RACK BRACKET (A) and (B) to the
19-inch RACK. See
• Carefully review every step above to ensure that all necessary screws
are properly placed and tightened.
Figure 2-8.
PANEL".
(B)".
RACK".
Figure 2-26.
CHAPTER 2 INSTALLATION
19-Inch Rack Mounting Installation
"Connection of
(B)".
(A)".
Page 85