NEC NEAX2000 IVS2 Installation Manual page 386

SWITCH
NAME
JPS
(Jumper pin)
JPR
(Jumper pin)
JP
(Jumper pin)
JP1
(Jumper pin)
The figure in the SWITCH NAME column and the position
column indicate the standard setting of the switch. When the switch is not set as shown by the
figure and , the setting of the switch varies with the system concerned.
NOTE 1: Set the groove on the switch to the desired position.
NOTE 2: When the power is on, flip the MB switch to ON (UP position) before plugging/
unplugging the circuit card.
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 3.0
CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS
SWITCH SETTING
NUMBER POSITION
RIGHT
LEFT
UP
DOWN
RIGHT
LEFT
DOWN
FUNCTION
Balanced transmission
(For twisted-pair cable)
TA is grounded on the transmission
line (For coaxial cable)
Balanced transmission
(For twisted-pair cable)
RA is grounded on the transmission
line (For coaxial cable)
Line impedance: 75 Ω
(For coaxial cable)
Line impedance: 120 Ω
(For twisted-pair cable)
Always set to DOWN
in the SETTING POSITION
PN-30DTC-C (DTI)
CHECK
Page 357