System Data Entry; Cat - NEC NEAX 2000 IPS Installation Manual

SYSTEM DATA ENTRY

There are two methods for data entry, using a Customer Administration Terminal (CAT)
or a Maintenance Administration Terminal (MAT).
NOTE: For assigning system data, refer to the "Command Manual".

CAT

term
Any D can be assigned as a CAT through programming. The D
phone when it is not in CAT mode. If the system is initialized by "C" (Resident System Program), every
term
D will be able to go into CAT mode. If the system is initialized by "B" (All Clear), only LEN000 is
assigned as a CAT port (the DLC card must be installed in slot LT00).
term
To use a D as a CAT, follow the procedures shown below.
NOTE:
It is necessary to complete Steps 1 through 6 within 4 seconds.
To set CAT mode:
TRF
1. Press
CNF
2. Press
- CNF/Conf lamp flashes
3. Press *
- CNF/Conf lamp is off
TRF
4. Press
CNF
5. Press
- CNF/Conf lamp flashes
#
6. Press
- CNF/Conf, SPKR/Speaker, FNC/Feature lamps are lit
- "CAT MODE" is displayed on the LCD
LNR/SPD
7. Press
- "COMMAND = -" is displayed on the LCD
Transfer
or
Conf
or
Transfer
or
Conf
or
Redial
or
term
– 278 –
CHAPTER 2 INSTALLATION

SYSTEM DATA ENTRY

ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
can still be used as a regular tele-
NWA-008841-001 Rev.5.0
90ch2002.fm