WAGO -I/O-SYSTEM 750 XTR Manual page 5

WAGO-I/O-SYSTEM 750 XTR
750-352/040-000 FC ETHERNET G3 XTR
8 Commissioning ....................................................................................... 85
8.1 Connecting Client PC and Fieldbus Nodes ........................................... 86
8.2 Assigning the IP Address to the Fieldbus Node .................................... 86
8.2.1
8.2.2
8.2.2.1
8.2.2.2
8.2.3
8.2.4
8.2.4.1
8.2.4.2
8.2.4.3
8.2.4.4
8.3 Testing the Function of the Fieldbus Node............................................ 98
8.4 Preparing the Flash File System ........................................................... 99
8.5 Setting Date and Time ........................................................................ 101
8.6 Restoring Factory Settings ................................................................. 103
9 Configuring via the Web-Based Management System (WBM) ........... 104
9.1 Information ......................................................................................... 106
9.2 Ethernet .............................................................................................. 108
9.3 TCP/IP ................................................................................................ 112
9.4 Port..................................................................................................... 114
9.5 SNMP ................................................................................................. 116
9.5.1
9.5.2
9.6 Watchdog ........................................................................................... 119
9.7 Security .............................................................................................. 121
9.8 MODBUS............................................................................................ 124
9.9 Features ............................................................................................. 126
9.10 I/O Config ........................................................................................... 127
10 Diagnostics............................................................................................ 128
10.1 LED Signaling ..................................................................................... 128
10.1.1
10.1.2
10.2 Fault Behavior .................................................................................... 137
10.2.1
10.2.2
Assigning IP Address via Address Selection Switch ......................... 86
Assigning IP Address via DHCP ...................................................... 88
Enable DHCP .............................................................................. 89
Assigning the IP address permanently by option "use IP from
EEPROM" ................................................................................... 89
Assigning IP Address via "WAGO Ethernet Settings" ....................... 91
Assigning the IP Address via BootP ................................................. 92
Note MAC ID ............................................................................... 93
Determining IP addresses ........................................................... 94
Assigning the IP address permanently by option "use IP from
EEPROM" ................................................................................... 95
Reasons for Failed IP Address Assignment ................................. 97
SNMP V1/V2c ................................................................................ 117
SNMP V3 ....................................................................................... 118
Evaluating Fieldbus Status ............................................................. 129
Evaluating Node Status - I/O LED (Blink Code Table) ................... 130
Fieldbus Failure ............................................................................. 137
Local Bus Failure ........................................................................... 137
Table of Contents
Manual
Version 1.3.0
5