Installing The Multi-Detector Drip Tray; Making The Ethernet Connection; Making Signal Connections - Waters ACQUITY Refractive Index Detector Overview And Maintenance Manual

Location of recycle tubing on recycle valve:
Location of
recycle tubing

Installing the multi-detector drip tray

If your system has more than one detector, you must install the multi-detector
drip tray. For information on how to install the multi-detector drip tray, refer
to the instructions included in the multi-detector drip tray kit.

Making the Ethernet connection

To make the Ethernet connection:
Connect one end of one Ethernet cable to the detector, and then connect
its other end to the network switch.

Making signal connections

The rear panel of the detector includes a removable connector that holds the
screw terminals for the optional I/O signal cables. This connector is keyed so
that it can be inserted only one way.
Refer to the signal connection location shown on the silk-screened label affixed
to the rear panel of the detector.

Installing the multi-detector drip tray

October 13, 2014, 715003547 Rev. C 45