Sea Recovery SRC Ultra Whisper Compact 200 Owner's Manual page 66

CONNECT TO
THRU HULL
INLET
FITTING
FEED W ATER
INLET
Figure 2.2.9 Illustration of the 5/8" braided hose connections on a Compact System.
FEED WATER 5/8" HOSE LINE
Use the 5/8" braided hose to Connect the 1/2" hose barb
on the 3/4" Inlet Elbow Assembly to the Sea Strainer
Inlet. Always use two 3/4" hose clamps when
assembling the 5/8" braided hose. Connect the Outlet
of the Sea Strainer to the Feed Pump then to the Pre-
filter Inlet Tee on the Compact Frame Assembly.
CONNECT TO ETD DISCHARGE HOSE BARB
CONNECT 5/ 8" HOSE TO ETD
DISCHARGE HOSE BARB
CONNECT TO
THRU HULL
DISCHARGE
Section 2 Page 27 of 68
Sea Recovery Ultra Whisper Rev. A
FITTING
REJECT WATER 5/8" HOSE LINE
Use the 5/8" braided hose to Connect the 1/2" hose barb
on the ETD Outlet labeled "S" to the 1/2" hose barb on
the Reject Water Assembly. The Reject Water
Assembly should be connected to the Thru Hull
Discharge Fitting.