Sea Recovery SRC Ultra Whisper Compact 200 Owner's Manual page 58

Figure 2.2.1 Illustration of the standard Modular Components required for installation.
CONNECT TO POTABLE W ATER TANK
Connect the 3/4" Elbow to the Inlet Thru Hull Fitting
or the Sea Cock Valve. The installer should use
common sense when installing the Inlet Thru Hull
Fitting, the Sea Cock Valve and the Inlet Elbow
assembly.
Install the Sea Strainer, Pre-filter Assembly, and Front
Panel Assembly to a bulkhead. The installer should
know where the hose and tube lines are going to be
placed before securing these components.
The Feed Pump, Energy Transfer Device, and
Membrane Vessel Assembly should be mounted to a flat
surface with enough surrounding area to allow for
maintenance. The Feed Pump and Energy Transfer
CONNECT TO
THRU HULL
INLET
FITTING
FEED W ATER
INLET
CONNECT TO
THRU HULL
DISCHARGE
Device must be mounted horizontally. The installer
should check the length of the high-pressure hose before
securing the Energy Transfer Device and Membrane
Vessel Assembly.
Section 2 Page 19 of 68
Sea Recovery Ultra Whisper Rev. A
FITTING