Sea Recovery SRC Ultra Whisper Compact 200 Owner's Manual page 180

Sea Recovery Ultra Whisper Rev. A
TOUCH PAD CONTROL DESCRIPTIONS:
SWITCHES
START: This switch initiates the start cycle of the Feed Pump
[6] and the System.
FRESH WATER FLUSH: This switch initiates the Fresh Water
Flush Cycle. When pressed, the Fresh Water Flush Cycle begins
and the Fresh Water Flush lamp illuminates steady green.
STOP: This switch stops all of the system functions when
pressed. Each time the system is stopped, the Fresh Water
Flush system is initiated as indicated by a steady illumination of
the Fresh Water Flush lamp. The Fresh Water Flush cycle is
aborted by pressing the Stop switch a second time.
FAULT RESET: This switch resets the High/Low Pressure fault
and allows the system to start.
INDICATION LAMPS:
Power: This indicator is illuminated when power is supplied to
the controller. This indicates that the main power breaker has
been switched on.
System On: This lamp illuminates when the System has been
Started and is operating.
Fresh Water Flush: This lamp illuminates continually during
the Fresh Water Flushing operation. When the Fresh Water
Flush is in the stand-by mode, in between the ten-minute
flushing cycle that repeats automatically every seven days, the
lamp illuminates intermittently on and off (blinks).
Product Water Quality: This lamp indicates the quality of the
water being produced by the system. A red illumination
indicates that the System is producing "un-potable" product
water that is being discharged over board. A green lamp
illuminates when the system is producing safe water (potable
water) that is being diverted to the potable water storage tank.
High/Low Pressure: The High/Low pressure fault lamp
illuminates when the system shuts down due to either a low-
pressure condition, or a high-pressure condition. During
operation if the Low Pressure Switch senses a low-pressure
condition, this lamp blinks for twenty seconds, and then the
system shuts down and the lamp remains illuminated until the
Fault Reset Switch is pressed. If the High Pressure Switch
senses a high pressure condition during operation the system will
shut down immediately and the lamp will illuminate until the
Fault Reset Switch is pressed.
section 6 page 33 of 38