Table of Contents
Advertisement
Sea Recovery Ultra Whisper Rev. A
CAUTION! Use the viewport to verify the proper operation of the UV lamp.
CAUTION! Rapid successive cycling of the power to the ballast can cause premature failure of the
unit.
CAUTION! Prior to energizing the lamp, make sure there is no water leaking from the quartz sleeve
compression nuts.
Mounting the Unit
Once the UV unit is assembled and tested successfully, it can be mounted onto its permanent operational location. The
unit must be mounted in a manner that will prevent excessive vibration and warping which will damage the quartz sleeve.
Operational Guidelines
a) Release the pressure in the UV treatment chamber before breaking the compression nut seals.
b) Disconnect all power to the UV unit before servicing.
c) Do not allow the inlet water temperature to drop below 35ºF (2ºC).
d) Do not allow the flow rate to exceed 2 GPM.
e) Do not cycle the UV unit more than 3 "ON/OFF" cycles in a 24-hour period.
f) Ensure all plumbing connections are tightly sealed before applying pressure.
g) Before connecting the return tube, flush the unit to rinse out any debris left from the installation process.
WARNING! UV LIGHT EXPOSURE CAN SEVERELY BURN AND DAMAGE EYES AND SKIN.
WARNING! DO NOT look at the blue UV light. DO NOT operate the UV lamp outside of the UV
treatment chamber.
CAUTION! The unit operates on high voltage and must be serviced by qualified personnel only.
CAUTION! Standard flow rate are based on water temperature 35ºF to 100ºF. If the inlet water
temperature exceeds 100ºF (38ºC), please contact your local CSR.
CAUTION! Cycling more than 3 cycles will reduce the end-of-life (EOL) output and/or cause
premature lamp failure.
Section 2 Page 68 of 68
Advertisement
Table of Contents
