Sea Recovery SRC Ultra Whisper Compact 200 Owner's Manual page 65

Sea Recovery Ultra Whisper Rev. A
CONNECT TO
THRU HULL
INLET
FITTING
FEED W ATER
INLET
Figure 2.2.8 Illustration of the standard Compact Components required for installation.
Connect the 3/4" Elbow to the Inlet Hull Fitting or the Sea
Cock Valve. The installer should use common sense
when installing the Inlet Hull Fitting, the Sea Cock Valve
and the Inlet Elbow assembly.
Install the Sea Strainer to a bulkhead. The installer
should know where the hose and tube lines are placed
before securing this component in place.
CONNECT TO
THRU HULL
DISCHARGE
FITTING
The Feed Pump and the Compact Frame Assembly
should be mounted to a flat surface with enough
surrounding area to allow for maintenance. The
Compact Frame Assembly comes with rubber washers
that are used a vibration insulators. The Feed Pump
must be mounted horizontally. Before securing the
Compact Frame Assembly, the installer should check
that a membrane element could be installed without
obstruction.
Section 2 Page 26 of 68