Table of Contents
Advertisement
Procedure to resurface the Sliding Distributor Panels
NOTE: Drain the ETD of feed water prior to dismantling.
1. Loosen both elbows (item #26) that hold both plastic tubes (Item #48) to be able to undo the connection
between these two components.
26
2. Loosen the six allen screws M8x40 (Item #30) that hold the joint distribution body and separate the set from
the rest of the ETD.
30
3. At this point both Sliding Distributor Panels are apart, it is necessary to pull with force to separate them from
the distribution body joint. Make sure the springs (Item #32) do not come out of their housing.
Joint
Distribution
Body
section 7 page 17 of 39
Sea Recovery Ultra Whisper Rev. A
48
Advertisement
Table of Contents
