Fig. 18 Brake Release; Fig. 19 Locking The Brake - Otto Bock C1000 Instructions For Use Manual

nOTE!
When in this position, the brake must still be
engaged! Should the brake already be
released and the pushing function be active at
this stage, please contact your wheelchair
supplier.
nOTE!
When the joystick is activated while the brakes
are unlocked, the control system emits an error
signal on the control panel. If this is not the
case, there is a malfunction that must be
corrected immediately by a specialist dealer.
fig. 18 Brake release
1 Brake release bolt
2 Brake release lever
C1000
Now the brake release lever has been released and can
be pressed fully forwards and downwards.
In this position, the control unit will recognise that the
brake has been released and automatically deactivate
the driving function. As soon as the joystick is deflected,
a warning will appear on the LCD display.
nOTE!
Once the brake unlocking lever has been
released, all braking systems are deactivated.
Locking the Brake
To lock the brake, push the brake release lever upwards
until the brake release bolt engages (see fig. 19).
To reactivate the driving function, switch off the wheelchair
controls and then switch them on again.
fig. 19 Locking the brake
12/2009
Operation
Page 111