Error; Defect / Failure - Otto Bock C1000 Instructions For Use Manual

Failures/Troubleshooting
9.2

Error

ATTEnTIOn!
Risk of injury if the power wheelchair stops
abruptly!
In the event of communication problems in the
bus system of the controls, the system triggers
an emergency stop to prevent any uncontrolled
functions. Depending on the source of the
malfunction, it is possible to drive the wheel-
chair out of a danger zone such as road traffic
after switching the controls on again.
If the driving function is still not available after
switching on the controls again, the brakes
must be released (see section 7.4) to switch
over to the pushing mode. After the power
wheelchair has triggered an emergency stop,
contact a specialist dealer as soon as pos-
sible!
An error affects one or several functions of the power
wheelchair. The system is not fully operational until the
error has been corrected.
Page 136
Error indication
Flashing signals of the LEDs:
Acoustic signal:
This process is repeated once per minute or once when
the power wheelchair is switched on.
9.3 Defect / failure
A defect represents a serious failure of a system compo-
nent.
After elimination of the fault, the system will be re-activa-
ted by re-starting it.
A failure represents the most serious kind of fault possi-
ble and results in an immediate emergency stop of the
system.
Defect or failure indication
The LEDs light up in quick succession, accompa-
❒
nied by an acoustic signal
12/2009
4 x per seconds
2 x per seconds
C1000