Mounting The Swing-Away Control Panel Holder; Retrofitting Attendant Controls - Otto Bock Xeno Service Manual

6.15.3 Mounting the Swing-away Control Panel Holder

Preparation:
❒ Remove the control panel (see Section 6.13.2).
Tools:
❒ Phillips screwdriver
Steps:
1. Separate the control panel and holder by loosening the four Phillips head screws on the un-
derside of the control panel holder.
2. Replace the control panel holder.
Properly reassemble all components upon completion of the work.
1 2 3
Figure 80 Mounting the swing-away control panel holder

6.15.4 Retrofitting Attendant Controls

Attendant controls are shipped as a mounting kit and are attached to the cross tube of the
backrest on the Xeno power wheelchair. Two bore holes are provided for this purpose on the
left and right of the back tube, respectively.
Figure 81 Attendant control
74