Additional Functions; Drive-Away Lock - Otto Bock C1000 Instructions For Use Manual

Operation
battery status is displayed after driving a short
distance.
7.3.6 Additional functions
The other electric additional functions, such as electric
back angle adjustment, seat tilt or electric footrests, are
also activated by pressing the key "M", which must be
held down for approximately 2 seconds.
The first LED of the speed level indicator is used for the
Servotronic; the connected additional functions can be
assigned to the other LEDs.
To change between the different functions, shortly press
the key "M" or move the joystick to the right. By moving
the joystick to the front or to the rear, the additional motor
can be activated or deactivated respectively. Press the
key "M" again to get back to the drive mode.
7.3.7 Drive-away Lock
Activation via control panel
Activation becomes possible only after release of the
parameter "drive-away lock". To activate the drive-away
lock press the warning flasher key (see fig. 14, item 3)
longer than 5 seconds. The control system confirms acti-
vation with a brief acoustic signal, and then turns itself
off.
Page 108
Activation via LcD
If a special control is used, the drive-away lock is acti-
vated using the LCD module. On the LCD display, select
the menu item "Drive-away lock" in the "Drive" mode.
Activation is confirmed with an acoustic signal and the
control is switched off.
Deactivation via control panel
When the drive-away lock is activated, the speed level
LEDs light up in quick succession when the power wheel-
chair is switched on.
To deactivate the drive-away lock move the joystick to the
front end position for approx. 3 seconds until you hear a
beep signal. Subsequently, move the joystick to the maxi-
mum rear position for approximately 3 seconds; once
again, an acoustic signal is emitted. Now the drive-away
lock is deactivated and the wheelchair can be driven.
nOTE!
If the joystick is not moved correctly, the
drive-away lock remains activated, even if the
joystick is moved once again and this time
correctly. The control system automatically
shuts off again after 10 seconds; then, the
power wheelchair can be switched on again
and the drive-away lock can be deactivated.
12/2009 C1000