Otto Bock C1000 Instructions For Use Manual page 139

Indicator Problem source
Battery
Right drive motor or
brake
Left drive motor or
brake
Input module error
Output module error
Impulse control error Error in the controller
Communication error Module is not connected;
Table 4 Overview of problem sources and corrective actions in case of errors
C1000
Possible cause
Battery is discharged or super-
charged
Right drive motor or brake not
connected;
poor contacts or broken cables
Left drive motor or brake not
connected;
poor contacts or broken cables
Joystick not in zero position;
joystick not properly calibrated at
system start;
defective input module
Defective connection to the output
module;
defective module
defective connection
12/2009
Failures/Troubleshooting
Possible measure
Charge or discharge, depending
on what battery indicator shows
Engage the brake release;
check motor cable and plug
connection on the controller
Engage the brake release;
check motor cable and plug
connection on the controller
Check mechanical initial position
and operation of the joystick;
restart
Check whether the plug contacts
are securely in place;
restart
Check whether the plug contacts
are securely in place;
restart
Check whether the plug contacts
are securely in place;
restart
Page 137