Fig. 42 Disassembling Drive Wheel; Fig. 43 Disassembling Caster Wheel - Otto Bock C1000 Instructions For Use Manual

To dismount a drive wheel, loosen the four Allen
❒
head screws in the middle of the wheel (see fig. 42)
and remove the wheel.
If the inner tube of a drive wheel needs to be
❒
replaced, loosen all Allen head screws on the inner
side of the rim and pull apart the two-piece rim.
The defective inner tube is now freely accessible and can
be replaced.
fig. 42 Disassembling drive wheel
C1000
To change the tyre of a caster wheel, proceed as follows:
To dismount the caster wheel, loosen the screw of
❒
the axle using a 6 mm Allen wrench (see fig. 43,
item 1) and pull out the axle.
Loosen all Allen head screws (see fig. 43, item 2)
❒
and separate the two-piece rim.
The defective inner tube is now freely accessible and can
be replaced.
fig. 43 Disassembling caster wheel
1 Axle screw
2 Allen head screw
12/2009
Maintenance, Cleaning and Care
Page 143