Adjusting The Track Width (Additional Adjustment) - Otto Bock Ventus Instructions For Use Manual

Settings
3) Loosen the clamping screw on the clamping flange (see fig. 13, item 1, see fig. 11, item 1).
INFORMATION: Note that the exchange can be made on one side first and then on the other or simul­
taneously.
INFORMATION: The track width must be adjusted symmetrically on both sides.
4) Remove the camber module:
→ Only for camber module 0°/3°: Insert the quick-release axle of the drive wheel into the camber module to
assist removal (see fig. 10, item 1/2) and pull it out with the help of the quick-release axle.
→ Only for camber module 6°/9°: Remove the camber module including fitting by hand (see fig. 12, item 1).
5) Replace and install the camber module.
→ Set the track width so that the slanted drive wheels can run freely (see Page 12).
→ Only for camber module 0°/3°: The entire camber module must be fully enclosed by the clamp bracket
during installation. Check the position by measuring it afterwards (see fig. 15).
→ Only for camber module 6°/9°: During installation, the camber module must be inserted in the clamping
flange to the stop (see fig. 12, item 2).
6) Clamp the camber module lightly using the clamping screw on the clamping flange.
7) Replace the camber module on the other side in the same fashion. Make sure that both camber modules have
been adjusted symmetrically.
8) Attach the wheels.
9) Make the track adjustments (see Page 14).
10) Tighten the clamping screws to 10 Nm (see fig. 13, item 1; see fig. 11, item 1).
9
11

6.2.4 Adjusting the track width (additional adjustment)

The 0° and 3° camber modules (see fig. 9, item 1) can slide in the clamping flange for adjusting the track width.
With the 6° and 9° camber modules (see fig. 9, item 2), the track is changed by adjusting the screwed in fitting
(see fig. 16, item 1).
Adjusting camber module 0°/3°
1) Remove the wheels.
2) Place the wheelchair upside down.
12
10
12
Ventus