Additional Options; Disassembly And Transport - Otto Bock Zenit Instructions For Use Manual

It is installed on the product by qualified personnel if needed and adapted to the requirements of the user.
Information about subsequent acquisition and mounting is provided by the qualified personnel that handed over the
product.
Using the lap belt
1) Open the buckle.
2) Place the user in an upright, 90° seated position (if physiologically possible). Ensure that the back is up against
the back support pad (if physiologically possible).
3) Close the buckle.
4) The lap belt should be at an angle of about 60° to the seat bottom. The belt strap should run across the thighs
in front of the pelvic bones (see fig. 36).
Possible errors
• The lap belt is positioned above the user's pelvis in the area of the soft part of the stomach.
• The user does not sit upright in the seat.
• If the lap belt is too loose, the user can shift/slide out to the front.
• During the installation/adjustment, the lap belt is routed over parts of the seating system (e.g. over forearm
supports or seat pads). This causes the lap belt to lose its retaining function.
36

7.13 Additional options

The product may be equipped with additional options.
The options are firmly mounted to the product by qualified personnel or the manufacturer and are pre-adjusted by
qualified personnel at delivery.

7.14 Disassembly and transport

CAUTION
Exposed pinch points
Crushing, pinching due to incorrect handling
► When folding the wheelchair out or together, only grip by the specified components.
NOTICE
Deformation when folded
Damage to the product, problems unfolding due to unallowable loads
► Never place heavy objects on the folded product.
INFORMATION
The disassembly described below may also be carried out the same way on the CLT model (not illustrated). The
"Folding back support" option is not offered for the Zenit CLT.
The wheelchair must be prepared for transport in a passenger vehicle.
Zenit; Zenit CLT – folding version
1) Apply the wheel lock.
Zenit
60°
Use
27