Table of Contents
Advertisement
Helvitica condensed 9 pt italic
C o d e
3 9
Configuration Commands
Configuration commands, like print mode commands, are effective when the
4100 is in Print mode. You should use configuration commands for the
following:
• Set parameters for configuration features
• Enable or disable options
Some configuration commands only take effect when the printer is reset or the
power is cycled. Some commands are effective immediately. If a printer reset
is needed, use the warm boot command (<BS>). The reset takes place after all
previous commands have been executed. This contrasts with the <DLE> reset
command, which executes immediately after it is received even if other
commands are waiting to be executed. The command string to enter Print
mode from Program mode is:
<STX>R<ETX>
Note: Each string of commands must be preceded by the start of message character
<STX>, and followed by the end of message character <ETX>. All configuration
commands are terminated by the next command in the message.
The following command descriptions explain the configuration commands that
are effective when the printer is in Print mode. The command descriptions are
listed in alphabetical order.
86XX or Advanced Mode on Power Up
Purpose:
Default:
Syntax:
Notes:
1 8
p t
Selects 86XX Emulation or Advanced mode on power up.
n=1
<SI>C{n}
n=0
Selects 86XX Emulation mode.
n=1
Selects Advanced mode.
To make this command effective, reset the printer or cycle
the power after issuing this command.
7
Printer Commands
7-31
Advertisement
Table of Contents
