Table of Contents
Advertisement
4100 Bar Code Label Printer User's Manual
13. Press [FEED] to advance a label through the printer.
14. Grasp the leading edge of the label where it has separated from the backing
Batch Take-Up Printing
Batch take-up printing (also known as label rewinding) allows you to print a
batch of labels without having to remove individual labels from the front of the
printer. As labels are printed, they are routed back inside the printer and
collected on the media rewinder hub. Later, you can remove the roll of printed
labels from the rewinder hub.
The printed labels are collected on the media rewinder hub after passing over
the rewind adapter mounted on the front of the printer beneath the driver
roller. The printer rewinder hub has a maximum capacity of 2,100 inches of
rewound media; it cannot rewind an entire roll of media.
The procedure for loading media for batch take-up printing includes setting up
the rewind adapter. Follow the steps below to prepare the printer for batch
take-up printing.
Tools required: Phillips screwdriver.
Installing the Rewind Adapter Before Printing
Before you can load the media for batch take-up printing, you must install the
rewind adapter that guides the printed labels out of the printer mechanism and
onto the media rewinder hub.
To install the rewind adapter
1. Open the front panel cover of the printer and remove the metal plate below
2. If the tear-off plate is installed, unscrew the two screws that fasten it to the
3-10
and pull it away from the printer.
the label dispense opening in the cover. The metal plate snaps in and out
using two small clamps on the left and right of the plate.
printer and remove the tear-off plate from the printer.
Helvitica condensed 9 pt italic
C o d e
3 9
1 8
p t
Advertisement
Table of Contents
