Table of Contents
Advertisement
Helvitica condensed 9 pt italic
C o d e
3 9
Loading the Media
With the rewind adapter in place, you are ready to load the media for batch
take-up printing. The first six steps of this procedure are shown in the
illustration for straight-through printing earlier in this section. Steps 7 to 9 are
shown in the illustration that accompanies this procedure.
1. Disengage the printhead by rotating the head lift lever clockwise to the UP
position.
2. Slide the retainer to the out of end of the supply mount and flip it down.
3. Place the label roll on the supply mount.
4. Flip the retainer to the upright position and slide the retainer firmly back
against the roll of media.
5. Rotate the media guide down.
6. Insert the label stock through the printer mechanism as shown in the
illustration. Make sure the front edge of the media passes through the label
gap sensor and over the top of the drive roller.
1 8
p t
1
2
5
4
3
Operating the Printer
3. Open the right side cover and
unscrew the knob that holds the
rewind adapter in place. Remove
the adapter from the printer.
When not in use, store the rewind
adapter below the media supply
hub at the back of the printer
interior.
4. With the front panel cover open,
place the rewind adapter where
the tear-off plate was attached.
5. Fasten the adapter to the printer
by turning the center knob
clockwise until the rewind
adapter fastens securely to the
printer. Make sure the top edge
of the rewind adapter is parallel
to the drive roller and the head
adjust plate.
4100-18a
3
3-11
Advertisement
Table of Contents
