Error Codes - Intermec EasyCoder 4100 User Manual

4100 Bar Code Label Printer User's Manual

Error Codes

Most of the problems you encounter will cause the 4100 printer to send an error
code to the host. When this happens, find the message in the table below and
follow the instructions to fix the problem.
Error
Code Problem
00 No error
01 Invalid bar code check character
02 Invalid number of bar code characters
(Code UPC/EAN)
04 Bar code check character within numeric
field marks
05 Supplemental delimiter within numeric
field marks (Code UPC/EAN)
06 Invalid supplemental character count
(Code UPC/EAN)
07 More than one supplemental delimiter
(Code UPC/EAN)
08 Invalid start/stop characters (Codabar)
11 Invalid bar code data
12 Data count exceeded
13 Entering data in non-data entry field
21 Quantity or batch count out of range
22 Field increment/decrement out of range
23 Intercharacter/message delay out of range Delay should be between 0 and 9999.
24 Missing preamble/postamble data
25 Invalid format transmission syntax
5-8
Helvitica condensed 9 pt italic
C o d e 3 9
Solution
Verify the bar code check character modifier used in the
bar code program command.
Verify the number of bar code characters used in the
bar code program command.
Check the bar code program command for accuracy.
Check the bar code program command for accuracy.
Check the bar code program command for accuracy.
Check the bar code program command for accuracy.
Verify start and stop characters in the label format.
Verify data in the label format.
Data count should not exceed what is specified for
field.
Check the field for accuracy.
Quantity of labels or number of batches should be
between 1 and 9999.
Quantity should be between 1 and 9999.
Delete the setup for preamble or postamble data, or
include the data.
Check the format transmission syntax. The correct
syntax is <ESC>x [n] with n ranging from 0 to 19.
1 8 p t