Printer Language, Select; Printhead Pressure, Set; Printhead Test Parameters, Set; Ribbon Save Zones, Set - Intermec EasyCoder 4100 User Manual

4100 Bar Code Label Printer User's Manual

Printer Language, Select

Purpose:
Default:
Syntax:
Notes:

Printhead Pressure, Set

Syntax:
Notes:

Printhead Test Parameters, Set

Syntax:
Notes:

Ribbon Save Zones, Set

Purpose:
Syntax:
7-40
Helvitica condensed 9 pt italic
C o d e
FrGoth
Selects the printer language.
n=0
<SI>l{n}
0 USA
1 United Kingdom
2 Germany
3 Denmark
4 France
Only one language is used per print job. See the
Appendix for international character sets.
This command is effective upon execution.
<SI>H{n}
The 4100 printer ignores this command.
<SI>U{n}{,m}{,p}{,q}
The 4100 printer ignores this command.
Defines the start and stop points of a ribbon save zone
within the label. This command does not enable inter-label
ribbon save.
<SI>Z{n,m}
n and m are the zone start and zone stop distances, in dot
increments, from the detected front of the label. The
difference between m and n depends on the speed
(number of ips) at which you are printing. Refer to the
table on the next page. Also, m must be bigger than n by at
least 100, or the command will be ignored.
3 9 1 8
5 Sweden
6 Italy
7 Spain
8 8-bit ASCII
9 Switzerland
p t