Table of Contents
Advertisement
4100 Bar Code Label Printer User's Manual
Do Not Repair or Adjust Alone
Do not, under any circumstances, repair or adjust energized equipment alone.
The immediate presence of someone capable of rendering aid is essential for
operator safety.
Do Not Repair or Clean With the Power On
Always turn off and unplug any device before cleaning or repairing it.
Accidentally turning on any piece of equipment while cleaning can cause a
serious injury.
First Aid
An injury, no matter how slight, should never be neglected. Always obtain first
aid or medical attention immediately after incurring an injury.
Resuscitation
Persons working on or near high voltage equipment should be familiar with
approved industrial first aid procedures. If someone is injured and stops
breathing, begin resuscitation immediately.
Energized Equipment
Electrical equipment is dangerous. Never work on energized equipment unless
authorized. Authorized emergency work on energized equipment must be
performed in strict compliance with current safety regulations.
Inspecting the Printer
Inspect the printer and the rest of your data collection system equipment on a
regular basis. Your inspections should include the following steps:
• Make sure the printer is properly grounded.
• Inspect the work environment. Large electric motors, welders, and
• Keep the printer away from liquids.
• Check the data collection network regularly for loose wires or poorly
4-4
switching equipment can affect printer performance. See Chapter 2,
"Installing the Printer," for guidelines on appropriate environments.
installed connections. Be sure to replace corroded wires.
Helvitica condensed 9 pt italic
C o d e
3 9
1 8
p t
Advertisement
Table of Contents
