Table of Contents
Advertisement
Helvitica condensed 9 pt italic
C o d e
3 9
Replacing the Fuse
If the Power On light does not come on when you turn on the printer, you may
need to replace the main power fuse. The fuse and fuse holder are located on
the rear of the 4100 printer. To replace the fuse, you will need a 1.5A Slo-Blo
fuse for 115 VAC operation. Printers that operate at 230 VAC use a 1.2A
double pole circuit breaker.
Warning
Always disconnect the power cord before replacing the fuse. Failure to
disconnect the power cord may result in injury or death due to electric shock.
WARNING
Avertissement
Débranchez toujours le cordon d'alimentation avant de replacer la fusible. Si
vous ne débranchez pas de cordon d'alimentation, vous courrez le risque de
blessure ou de mort par électrocution.
To replace the fuse
1. Turn off and unplug the printer.
2. Turn the fuse holder half a turn counterclockwise.
3. The fuse holder will pop out. Pull the fuse holder from the printer.
4. Remove the old fuse from the holder.
5. Install the new fuse in the holder
6. Press the fuse holder into place and turn it half a turn clockwise or until it
7. Connect the power cord to the printer.
8. Turn on the printer. If it still does not receive power, contact your Intermec
1 8
p t
stops.
representative.
Routine Maintenance
4
4-17
Advertisement
Table of Contents
