Configuration Commands; Auto-Transmit 1, Enable; Auto-Transmit 2, Enable - Intermec 4630 User Manual

4630 and 4830 Bar Code Label Printers User's Manual

Configuration Commands

Configuration commands, like Print mode commands, are effective when the
printer is in Print mode. Use configuration commands to
•
•
Configuration commands come into effect when the printer is reset or the
power is cycled. If a printer reset is needed, the warm boot command should
be used. The reset will take place after all previous commands have been
executed. This contrasts with the <DLE> reset command, which executes
immediately after it is received even if other commands are waiting to be
executed. The command string to enter Print mode from Program mode is:
<STX>R<ETX>
Note: Each string of commands must be preceded by the start of message character
<STX>, and followed by the end of message character <ETX>. All configuration
commands are terminated by the next command in the message.
The following command descriptions explain the configuration commands that
are effective when the printer is in Print mode. The command descriptions are
listed in alphabetical order.

Auto-Transmit 1, Enable

Purpose: Enables auto-transmit level 1.
Syntax:
<ESC>j
Status response codes:
<DC1>
<FS>
<BS>
<EM>
<US>
<US>
Notes: The printer automatically transmits the status response codes when necessary.

Auto-Transmit 2, Enable

Purpose: Enables auto-transmit level 2.
Syntax:
<ESC>d
Notes: The printer automatically transmits the status response code <DC1>.
6-30
set parameters for configuration features.
enable or disable options.
Fault cleared
Label at strip pin
Takeup reel full
No label stock
Ribbon fault
Label path open