4100 Bar Code Label Printer User's Manual
Control Panel Access Permission, Set
Syntax:
Notes:
Cutter, Enable or Disable
Purpose:
Default:
Syntax:
Notes:
Dark Adjust, Set
Purpose:
Default:
Syntax:
Notes:
End-of-Print Skip Distance, Set
Purpose:
Default:
Syntax:
Notes:
7-34
Helvitica condensed 9 pt italic
C o d e
FrGoth
<SI>A{n}
This command is ignored by the 4100 printer.
Enables or disables the label cutter.
n=0
The cutter is enabled if n is non-zero.
<SI>c{n}
The optional cutter must be installed before this command
is used. This command is buffered up and becomes
effective after the printer is repowered or reset.
Sets the dark adjust command. This controls the print
darkness on the labels.
n=0
<SI>d{n}
n ranges from -10 to +10 in increments of one. The darkest
setting is +10 and the lightest setting is -10.
This command becomes effective upon execution.
Sets the end-of-print skip distance. This distance is a value
in dot size increments that the label advances after
printing or when printing is paused.
n = 0
Label stock mode
n = 118 Continuous stock mode
<SI>D{n}
n must be a number from 0 to 9999 in dot size increments.
To advance the label out to the tear bar in label stock
mode, set n to 108.
3 9
1 8
p t