Message Delay, Set; Number Of Image Bands, Set; Online Or Offline On Power Up - Intermec EasyCoder 4100 User Manual

4100 Bar Code Label Printer User's Manual
Syntax:
Notes:

Message Delay, Set

Purpose:
Default:
Syntax:
Notes:

Number of Image Bands, Set

Purpose:
Default:
Syntax:
Notes:

Online or Offline on Power Up

Syntax:
Notes:
7-38
Helvitica condensed 9 pt italic
C o d e
<SI>g{n}{,m}
FrGoth
You can use n to select direct thermal (DT) or thermal
transfer media on some printers. However, this parameter
can only be set by the Transfer On switch on the front of
the 4100 printer.
Use m to set the media sensitivity. See Chapter 3,
"Operating the Printer," for details on setting this
parameter.
This command is effective upon execution.
Sets the message delay to n milliseconds.
n=0
<ESC><SYN>{n}
n must be a number from 0 to 9999 milliseconds. n is the
delay at the start of a printer transmission.
This command is effective upon execution.
Selects the number of image bands.
n=3
<SI>I{n}
n must be a number from 2 to 6 if you have 32K of static
RAM in the printer. If you have expanded RAM in the
printer, n can range from 2 to 12.
This command is effective upon execution.
<SI>O{n}
This command is ignored by the printer.
3 9 1 8 p t