Table of Contents
Advertisement
4100 Bar Code Label Printer User's Manual
User-Defined Tables, Transmit
Purpose:
Syntax:
Notes:
Warm Boot
Purpose:
Syntax:
Notes:
7-30
Helvitica condensed 9 pt italic
C o d e
FrGoth
This command causes the printer to upload the user-
defined command and protocol tables that the printer
receives to download a new command set.
<ESC>Z{t}
The command table identifier t has the following values:
t = 0
Print mode commands
t = 1
Escape print commands
t = 2
Shift print commands
t = 3
Status response
t = 4
Protocol characters
Tables listing the default values are located at the end of
the Program mode command descriptions under "User-
Defined Interface Tables".
An error code (12) is generated if an invalid number is
entered.
This command is used to substitute protocol and
command characters.
Resets the printer with a warm boot.
<BS>
Unlike the <DLE> command, this command does not take
effect immediately. It waits until all previous commands
have been executed before it takes effect.
Data sent after this command, or before the printer
finishes rebooting, are lost.
This command is useful when configuration changes
require a printer reset.
3 9
1 8
p t
Advertisement
Table of Contents
Need help?
Do you have a question about the EasyCoder 4100 and is the answer not in the manual?