Configuring The Igmp Leave Timer - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 21
Configuring IGMP Snooping and MVR
Immediate Leave is supported only on IGMP Version 2 hosts.
Note
Beginning in privileged EXEC mode, follow these steps to enable IGMP Immediate Leave:
Command
Step 1
configure terminal
Step 2
ip igmp snooping vlan vlan-id
immediate-leave
Step 3
end
Step 4
show ip igmp snooping vlan vlan-id
Step 5
copy running-config startup-config
To disable IGMP Immediate Leave on a VLAN, use the no ip igmp snooping vlan vlan-id
immediate-leave global configuration command.
This example shows how to enable IGMP Immediate Leave on VLAN 130:
Switch# configure terminal
Switch(config)# ip igmp snooping vlan 130 immediate-leave
Switch(config)# end
Configuring the IGMP Leave Timer
Follows these guidelines when configuring the IGMP leave timer:
•
•
•
•
•
Beginning in privileged EXEC mode, follow these steps to enable the IGMP configurable-leave timer:
Command
Step 1
configure terminal
Step 2
ip igmp snooping
last-member-query-interval time
Step 3
ip igmp snooping vlan vlan-id
last-member-query-interval time
Step 4
end
OL-26520-01
You can configure the leave time globally or on a per-VLAN basis.
Configuring the leave time on a VLAN overrides the global setting.
The default leave time is 1000 milliseconds.
The IGMP configurable leave time is only supported on hosts running IGMP Version 2.
The actual leave latency in the network is usually the configured leave time. However, the leave time
might vary around the configured time, depending on real-time CPU load conditions, network delays
and the amount of traffic sent through the interface.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Purpose
Enter global configuration mode.
Enable IGMP Immediate Leave on the VLAN interface.
Return to privileged EXEC mode.
Verify that Immediate Leave is enabled on the VLAN interface.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Configure the IGMP leave timer globally. The range is 100 to
32768 milliseconds. The default is 1000 seconds.
(Optional) Configure the IGMP leave time on the VLAN interface. The
range is 100 to 32768 milliseconds.
Configuring the leave time on a VLAN overrides the globally
Note
configured timer.
Return to privileged EXEC mode.
Configuring IGMP Snooping
21-11
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
