Table of Contents
Advertisement
CC# Assign (1–8)
This read-only parameter shows the MIDI CC sent by the
slider.
Control Surface - RT/KARMA
Selected
Parameter
Information
0–9e
0–9e: RT/KARMA (Real Time
Knobs/KARMA)
This Control Assign (labeled R. Time Knobs/KARMA on
the front panel) setting lets you modulate Program and
Effects parameters with the eight knobs, and control
KARMA with the switches and sliders.
Selected parameter information
When you select a KARMA Slider or Switch, this area
shows detailed information about its KARMA parameter
assignments.
Control
This shows which Switch or Slider is currently selected.
Assignment
Each KARMA Slider or Switch can control multiple internal
parameters simultaneously. The group of parameters can be
given a single name, which is shown here.
You can select different names, if desired. For more
information, see "7–9: Name/Note Map" on page 137
Module and Parameter
This read-only display shows the KARMA parameter(s)
assigned to the Slider or Switch.
A means that the slider or switch controls a GE Real-Time
Parameter from KARMA Module A. (Note that in Program
mode, only Module A is available.) The following number
identifies the specific parameter within the module. For
instance, A22 is parameter 22 of Module A.
P means that the switch is controlling a Performance Real-
Time Parameter.
[Off, 000...119]
[SW1...8, SL1...8]
[Name]
[A 01...32, P 01...08]
Program P0: Play 0–9: Control Surface
Value (1–8)
This is the current value of the slider's MIDI CC.
You can assign many parameters to a single slider or switch,
if desired. Due to space limitations, however, only the first
five parameters will be shown here.
To change the parameter assignments, use the KARMA GE
RTP and Perf RTP pages. For more information, please see
"7–5: GE Real-Time Parameters/Scenes" on page 124, and
"7–6: Perf Real-Time Parameters" on page 127.
Parameter Value
This shows the value of the GE or Performance Real-Time
Parameters assigned to the selected Slider or Switch. The
range can vary, depending on the individual parameters.
Knobs 1–8
Knobs 1–4 all have dedicated functions which correspond to
MIDI CCs. Knobs 5–8 can be assigned to a wide variety of
functions, many of which also have corresponding MIDI
CCs.
When you move a knob, it sends out the corresponding
MIDI CC. Also, when the CC is received via MIDI or
generated by KARMA, the knob value changes to match the
CC value.
Unless otherwise noted, "scaling" means that the parameters
are at their programmed values when the controller is at 64,
at their minimum when the controller is at 0, and at their
maximum when the controller is at 127. For another look at
this, see the diagram below.
[000...127]
[Depends on parameter]
33
Advertisement
Table of Contents
