Omni/St Page; Monitor The Output Levels Of The Omni Out Jacks And Stereo Output - Yamaha AW4416 Reference Manual

HOME screen
Monitor the output levels of the OMNI OUT jacks and
stereo output
[Function]
Monitor the output levels of OMNI OUT
jacks 1–4 and the stereo output.
[Key operation]
• [HOME] key [F4] (Omni/ST) key
• Repeatedly press the [HOME] key until
the screen shown at the right appears
[Mouse operation]
M button HOME button
[Screen functions]
A
OMNI OUT level meters
These meters show the output level of OMNI
OUT jacks 1–4. The type of signal assigned to
each OMNI OUT jack is indicated below each
level meter.
Tip!
This page is for display only; assignments
cannot be changed in this page. The signals
assigned to OMNI OUT jacks 1–4 can be
selected in the SETUP screen Patch OUT
page.
B
STEREO OUT level meter
This meters shows the output level of stereo out-
put.
C
STEREO OUT LEVEL
This shows the position of the STEREO fader in
dB units.
D
PRE FADER (pre-fader) button
E
POST FADER (post-fader) button
Select one of these two buttons to select the
location in the signal path (pre-fader/post-fader)
whose level will be shown by the STEREO OUT
level meters.
78
— Reference Guide

Omni/ST page

1
Omni/St tab
2
3 4
The PRE FADER button/POST FADER button
setting will not affect the OMNI OUT level
meter display.
Additional functions in the Omni/
ST page
In the Omni/ST page you can press the [SHIFT] key
to assign the following function to the [F1] key.
F1
• [F1] (PEAK HOLD) key
This key sets/defeats the Peak Hold function.
This is the same function as the [PEAK HOLD]
key in the level meter/counter section.
5