Editing Data For Each Channel (Channel) - Yamaha DGX-670 Reference Manual

Editing Data for Each Channel (Channel)

The instructions below apply to step 6 of the Basic Procedure on
recorded data for each channel of the current Section selected on the Basic page or via the panel buttons.
1
In the Channel page, use the Cursor buttons [][] to select the edit menu.
3
1 Quantize
Same as in the Song Creator
2 Velocity Change
Boosts or cuts the velocity of all notes in the specified channel, according to the percentage specified here.
3 Bar Copy
This function allows data to be copied from one measure or group of measures to another location within
the specified channel.
[4 ]
[5 ]
[6 ]
4 Bar Clear
This function clears all data from the specified range of measures within the selected channel.
5 Remove Event
This function lets you remove specific events from the selected channel.
2
Use the [2 ] (Channel) buttons to select the channel to be edited.
The selected channel is shown at the upper left of the display.
3
Use the [3 ]–[7 ] buttons to edit the data.
4
Press the [ENTER] button to actually enter the edits for each display.
After the operation is completed, "Undo -> [ENTER]" is displayed. You can restore the original data if
you are not satisfied with the results of the edit by pressing the [ENTER] button. The Undo function only
has one level; only the previous operation can be undone.
NOTICE
The edited Style will be lost if you change to another Style or turn off the power to the instrument without carrying out the Save operation
(step 8 on page
36
DGX-670 Reference Manual
1
2
(page 56), with the exception of the two additional available parameters below.
Top Specifies the first (Top) and last (Last) measures in the region to be copied.
Last
Dest. Specifies the first measure of the destination location, to which the data is to be
copied.
27).
27. On the Channel page, you can edit
page
Eighth notes with swing
Sixteenth notes with swing
3