–
replace if damaged
4 -
6 Nm
5 -
Air filter top part
6 -
Filter insert
7 -
Air filter bottom part
8 -
Air deflector
Removing and installing engine covers
Removing
Lever out the plugs -1- at the points marked
–
with arrows and slacken the securing nuts -2-
for both engine covers.
Slacken the securing nut -3- and remove the
–
engine covers.
Install
Installation is carried out in the reverse order. Pay
attention to the following:
Tighten securing nuts to 8 Nm and press in the
–
plug.
Testing lines and components with the test box -V.A.G 1598/22-
Note
t Use e.g. hand multimeter -V.A.G 1526A-, then voltage tester , e.g. -V.A.G 1527- for the test.
Use adapter cables from adapter cable set for connecting the test equipment to the test
t
box -V.A.G 1594A -.
The contact numbers of the connector of the control unit and the socket numbers of the
t
test box are identical.
–
Unlock connector at control unit when the ignition is switched off.
194