Setting Up Via Gsd - WAGO 750-484 Manual

2 ai 4-20 ma hart ex i 2-channel-analog input module 4-20 ma hart, ex i

Hide thumbs Also See for 750-484:

Table of Contents

WAGO-I/O-SYSTEM 750

750-484 2 AI 4-20 mA HART Ex i

9.1.2

Setting Up via GSD

When connecting to a PROFIBUS DP/V1 Fieldbus Coupler 750-333 or Controller

750-833, assuming that the HART I/O module is supplied in the default operating

mode, the mode must be changed over accordingly. The parameters for the

required operating mode can be set using the GSD files.

Additional Information for Download the GSD Files

The GSD files can be downloaded free of charge from the WAGO website at:

www.wago.com → Support → Additional documentation and information on

automation products → WAGO Software → WAGO-I/O-PRO / CODESYS.

You can find the link to "Libraries" in the column "Additional Information" on

the right side.

Before setting the parameters however, the components of the PROFIBUS

system, which define the structure of the input and output process image, must

first be configured.

The GSD files for PROFIBUS are read in or installed by the configuration

software used. These provide the characteristic device data necessary for

configuration, particulars of their communications capability and other

information. The size of the process images is then determined by the compiled

configuration data.

Additional Information on Installing the GSD Files

Please refer to the documentation for the configuration software which you are

using for information on installing the GSD files.

The required operating mode for the HART I/O module can be selected and

specified right at the configuration stage.

Further data for the HART I/O module can then be specified in a parameterization

dialog box corresponding to the selected module.

Manual

V 1.2.0 HW-Version 04, SW-Version 03

Operating Modes

Table of Contents

Table of Contents