Table 57 Apl Led; Table 58 Profinet Io-Device Status; Table 59 Led States - Profinet Io-Device; Table 60 Ethernet Status - WAGO 765-1103/100-000 Manual

Diagnostics
LED
APL
PROFINET IO-Device Status
The BF and SF LEDs indicate the status of the PROFINET IO-Device. The LNK and ACT
LEDs indicate the ETHERNET status.
PROFINET IO-Device Status
The following table describes the LED states of the PROFINET IO-Device.
LED
BF (bus error)
SF (system error)
LED State
Flashing (1 Hz, 3 s)
Flashing (2 Hz)
ETHERNET Status
The following table describes the LED states of the link and activity LEDs.
LED
LNK
ACT
96 Product manual | Version: 2.2.0
16DO FLD PN DC 24V 2.0A
Color State
Duo LED, red/green/yellow (yellow = simultaneously red and green)
Off Off
Yellow Flashing (1 Hz, 5 s)
Color State
Red LED
Off Off
Red Flashing (2 Hz)
Red On
Red LED
Off Off
Red Flashing (1 Hz, 3 s)
Red On
Description
The indicator switches on and off for 3 second in phases at a fre-
quency of 1 Hz: on for 500 ms and then off for 500 ms
The indicator switches on and off in phases at a frequency of
2 Hz: on for 250 ms and then off for 250 ms
Color State
LED green
Green On
Off Off
LED yellow
Yellow Flickering (load-de-
pendent)
Off Off
765-1103/100-000
Table 57: APL LED
Description
LED with no function
Module has a NameOfStation and/or an IP
address. During module startup, the LED
flashes for 5 s at 1 Hz.
Table 58: PROFINET IO-Device Status
Description
No error
No data exchange
No configuration, slow physical connection
or no physical connection
No error
DCP signal service is triggered via the bus
Watchdog timeout; channel, generic or ex-
tended diagnostics present; system error;
forcing active
Table 59: LED states – PROFINET IO-Device
Table 60: ETHERNET Status
Description
The module is connected to ETHERNET
The module is not connected to ETHER-
NET
The module is sending/receiving ETHER-
NET frames
The module is not sending/receiving ETH-
ERNET frames