Tcp/Ip" Page; Table 30: Description Of The Parameters Of The "Tcp/Ip" Page - WAGO -I/O-IPC-C6 Manual

70 Configuration
9.1.4

"TCP/IP" Page

On the page for TCP/IP configuration, change the parameters for the ETHERNET
configuration. To accept your entries, click on the [SUBMIT] button.

Table 30: Description of the Parameters of the "TCP/IP" Page

Common Configuration Data
Host Name
Default Gateway
None
X8
X9
Value
DNS Server
Domain Name
DNS-Server 1, 2, ...
Add DNS Server
TCP/IP Configuration Eth0/Eth1
State
Enabled
Disabled
Type of Address Configuration
Static IP
DHCP
BootP
Configuration Data
IP Address
Subnet Mask
758-874/000-110 WAGO-I/O-IPC-C6
If you have chosen the dynamic assignment of an IP address
through DHCP, enter the host name of your PC here so that your
PC can connect to the ETHERNET network.
This is where you select the interface that should be used as the
default gateway. The default gateway is used by the I/O-IPC if
the target address lies outside of the individual network.
Enter the address of the default gateway here.
Set the domain name here.
Set the address of the DNS server here.
Accept the DNS address.
[CHANGE]:
Deletion of the DNS address (line is
[DELETE]:
removed).
Add additional DNS addresses here.
Activate the corresponding ETHERNET interface here.
Deactivate the corresponding ETHERNET interface here.
Here, choose whether you would like to use a static or dynamic
IP address.
Static IP:
DHCP and BootP:
Here, enter a static IP address. This is active if "Static IP" is
activated in the "Type of Address Configuration" field.
Here, enter the subnet mask. This is active if "Static IP" is
activated in the "Type of Address Configuration" field.
WAGO-I/O-SYSTEM 750
Static IP address
Dynamic IP address
Version 2.3.0
Manual