Powering Down The Projector - Christie CP2000-M User Manual

Section 3: Operation
1. Connect the projector's line cord to the AC receptacle at the lower-left rear corner of the projector and to
proper AC - the outlets must be near the equipment and easily accessible. Use only the line cord provided
with the projector or a power cord of appropriate ratings that comply with regional standards. When the
main inlet is used the AC switch must be set to the left (Figure 3-2).
2. An optional feature to power all electronics through a UPS is available using the secondary inlet (cord not
provided). When the secondary inlet is used the AC switch must be set to the right (Figure 3-2). This
feature enables users to power all electronics through a UPS, which minimizes downtime in the event of a
brief power outage.
3. From the CDP, press Power ON and hold for 2 seconds to fully power up the projector, which takes
approximately 2 minutes, in preparation for igniting the lamp. NOTE: If the Lamp ON key is selected
while the projector is in STANDBY mode, power is first turned ON and then the lamp is ignited.
4. From the CDP, press Lamp ON and hold for 2 seconds to turn the lamp and lamp fans ON. Once pressed
the green ON and amber READY status LEDs flash slowly until the lamp is ignited, at which point the
READY LED turns OFF and the ON LED turns solid.
If Lamp Fails to Ignite:
If a safety interlock switch is open (i.e., lamp door open), the lamp cannot be struck until the interlock problem
is resolved. The Error LED on the CDP is illuminated red and flashing, and the LCD Status Display Window
displays ERROR:StrikeFail. If the lamp fails to ignite even though the interlock system is ok, the
projector automatically attempts ignition using 100% of the maximum power acceptable for the installed lamp.
If this fails, a new lamp is likely required.
3.3

Powering Down the Projector

approximately 15 minutes to ensure the projector and lamp have sufficiently cooled, at which
point the fans automatically shut-off. To avoid thermal stress that can lead to premature lamp
failure, never unplug the line cord while the fans are running and never unplug to power
down.
1. From the CDP, press
fast lamp ON response, if needed.
3-4
Figure 3-2 Connecting To Power
Once the projector is powered down, the fans continue to run for
. In this state the projector is still in POWER ON mode, which allows for
LAMP OFF
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)