Section 5: Maintenance
5.6.2 Insert New Lens
1. Remove the small rear cap. Keep the front cap on.
2. Align the mounts on the lens connector with the lens
mount. Insert the lens until it connects with the
magnets on the mount. Once the lens makes contact
with the magnetic plates it will be seated correctly
and the connector for motorized zoom and focus will
be properly connected (Figure 5-5).
3. For added stability, secure the cap screws provided
on the lens-mount. If you have installed a large zoom
lens, one or more of the screws may be inaccessible-
simply tighten those that are accessible. NOTE:
Recommended for heaviest lenses, such as 0.8:1 and
1.3-1.75:1.
5-10
Figure 5-5 Install Lens
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)