Christie CP2000-M User Manual page 68

Section 3: Operation
• Data Format: Identifies the source type (8-10-12 bit) and whether or not it is packed. The projector
processes the incoming signal according to the data format selected here. Available data formats depend on
which projector input is selected and resets to a default value if an input has not yet been selected. Data
format settings are not included in a PCF.
• Source*: Identifies/sets the expected incoming source resolution and aspect ratio, such as 1998x1080 Flat.
The list of available sources are defined using the Admin: Source menu.
• Screen: Identifies/sets display area, masking (cropping) and expected lens for the current source. Choices are
pre-defined using the Admin: Source menu. Screen settings are not included in a PCF.
A Gamma: Applies gamma correction
B Color Space: Applies type of color decoding
(RGB or YCbCr)
C Target Color: Applies custom color processing
(defined in Admin: General)
D Measured Color: Native color reference (Defaults
to OnSite)
E Activate: Enabled when active channel selected
F Re-Sync: Enable/disable re-synchronization
Summary of Channel: Page 2 Options
• Measured Color: Identifies/sets the desired MCGD file for a given channel/source (representing native
"uncorrected" colors) to use as a reference for calculating target color processing. MCGD files are defined in
the Admin: MCGD menu.
• Target Color*: Identifies/sets the special color processing called Target Color Gamut Data established for a
given presentation.
• Color Space*: Identifies/sets the method of color decoding for the current source. Default = RGB for all
DVI-D sources. Default = Unity RGB for all cinema sources (i.e., SMPTE Dual-292 or JPEG2000).
• Gamma*: Identifies/sets the desired gamma (a.k.a. "de-gamma") correction needed for proper tonal range
of the source material. For example, a grayscale test pattern is neutral and smoothly graduated.
3-30
Figure 3-20 Channel: Page 2
G Change Icon: Press to change icon for cur-
rent channel
H Resets Settings Back to Factory Defaults
I LUT-CLUT: Complex color look-up table -
applies a 3-dimensional color cube for
increased color accuracy. Not available when
using a pre-defined PCF file
J Pull Down Sequence
K Pull Down Offset
L SMPTE Field Bit
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)