Powering Down The Projector; Using The Control Display Panel (Cdp); Cdp Key Descriptions - Christie CP2000-ZX Setup Manual

3.3.1 Powering Down the Projector

1. On the CDP, press LAMP OFF. NOTE: The projector is still in "power on" mode, which allows for fast
lamp on response, if needed.
2. On the CDP, press POWER OFF. The lamp will power OFF first and then the projector automatically
enters a cool down mode where the fans and electronics stay on for 15 minutes. After this cool down
period, the projector enters standby mode and all fans and most electronics will power down.
3. If you will be servicing or removing any projector cover, disconnect AC.
3.4

Using the Control Display Panel (CDP)

The CDP provides fast and easy local operation and monitoring of various projector functions. It is located on
the back panel of the projector, but for convenience can be removed and installed in an alternate location in the
projection room. NOTES: 1) Do not use the CDP as a handheld remote. It is designed for fixed installation
only. 2) An optional 25ft extension cable kit (Christie P/N 108-283101-01) is available to allow installation of
the CDP in another location.
In most cases, the CDP will be the primary interface with the projector. For more sophisticated setup and
diagnostic controls, refer to

3.4.1 CDP Key Descriptions

Menu - Display Main Menu
(toggle).
Navigation Arrow Keys -
Adjust settings up or
down.
Navigate within window.
NOTE: Play and Stop for
future use.
Power ON / Power OFF -
Use these buttons to turn
the projector ON or OFF.
NOTE
: Push and hold
these keys for a half sec-
ond to activate.
CP2000-ZX Setup Guide
020-100098-04 Rev. 1 (06-2009)
Section 3.5 Using the Web User Interface.
Figure 3-1 CDP Features
Section 3: Basic Operation
Projector Status Indicators
Exit - Return to previous menu level.
If in an editing window, press once to
abort the edit, press again to exit the
current menu.
Enter - Select a highlighted menu
item; change or select a menu item.
Lamp ON / Lamp OFF - Use these
buttons to turn the lamp ON or OFF.
NOTE
: You can also go from standby
mode directly to lamp on using Lamp
ON button.
Douser Open / Douser Closed - Use
these buttons to change the status of
the douser. Closing the douser
reduces lamp power.
3-5