Shut Down The Projector - Christie CP42LH Service Manual

Shut down the projector

Perform these steps before servicing the system.
1. Move the projector breaker switch to the off position.
2. Disconnect the projector from AC power.
3. Rotate the beam stop to the closed position.
4. Remove the key from the laser rack key switch.
Projector covers and components
Never operate the projector or the fans without all the covers installed. Failure to comply
could result in minor or moderate injury.
Shroud
Estimated replacement time: 2 minutes
1. With light pressure, push down on the top of the shroud while
pushing upward on the bottom of the shroud.
2. Carefully slide the shroud sideways and forward away from
the lens mount and the lens.
3. Set the shroud covers on a clean, stable surface.
Front top lid
Estimated replacement time: 0.5 minutes
1. Using the low security key, unlock the cover.
2. Lift the cover up and remove.
CP42LH Service Manual
020-101686-03 Rev. 1 (08-2016)
Parts and Module Replacement
2
1
41