Section 2: Installation & Setup
2.3.3 Carrying/Moving the Projector
distance. It is strongly recommended, the projector be kept as level as possible when carrying
up stairs or lifting onto a table. Titling the projector excessively should be avoided as it can
introduce air bubbles within the coolant hoses, which can lead to an air lock.
when it has been levelled.
2.4
Maximizing Light Output
Perform LampLOC™ adjustment when the projector is first installed and initially powered up, anytime the
lamp is replaced or inspected, and whenever the projector is moved and leveled. This adjusts the lamp position
to ensure optimal operation, as well as peak screen brightness. Once LampLOC™ adjustment is complete, the
lamp will be well-centered and distanced correctly from the remainder of the illumination system.
Before adjusting LampLOC, ensure the following criteria are met:
Lamp must be ON and the douser (shutter) open during adjustment.
Display a white test pattern. This is recommended to view LampLOC™ progress on screen.
To automatically adjust LampLOC:
1. Select LampLOC Auto from the CDP Lamp>LampLOC menu (Figure 2-11).
2. Allow a few minutes to pass to allow the LampLOC mechanism to establish the best lamp position and to
optimize light output. When operation is complete "100%" is displayed on screen.
NOTE: LampLOC can also be adjusted manually using the CDP LampLOC Manual option, or from the web
user interface Advanced: Lamp menu. For more details on manual adjustment, refer to
2-12
Two people are required to safely lift and hand-carry one projector a short
Auto LampLOC™ must be run any time the projector is physically moved or
Figure 2-11 Adjusting LampLOC From CDP Menu
Section 3
Operation.
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)