Christie CP2000-M User Manual page 150

Appendix A: Serial API
Table A.1 Function Codes
EXAMPLES:
(MCG+C108 "Nominal") Use file "Nominal" on channel
(MCG+C108?) get measured color file name on channel 108
(MCG?L) list all entries of measured color control
Channel_Name (NAM)
DESCRIPTION
Set the descriptive channel name for the specified channel.
SUBCODE
Cxxx
None
EXAMPLES:
(NAM+C108 "Scope 2.39") set channel name for channel 108
(NAM+C108?) get channel name for channel 108
Network Setup (NET)
DESCRIPTION
Set or request the network setup for this device. ETH0 and ETH1 are non transferable settings.**Kevin asked to not mention
ETH1. MAC0 and MAC1 are read only settings.
(ETHO).
SUBCODE
DLP0
DOMA
ETH0
ETH1
GATE
HOST
MAC0
MAC1
SUB10
SUB1
A-14
DESCRIPTION OF USE
Replace xxx with the channel number. Valid Range is 101 - 164.
Select channel name for the current channel.
Note: Some devices may only have 1 Ethernet controller
DESCRIPTION OF USE
IP Address for the Cinema Electronics.
Set the domain name.
Set the IP address for the first ethernet controller.
Set the IP address for the second ethernet controller.
Set the network gateway.
Set the host name.
Gets the MAC address of the first ethernet controller.
Gets the MAC address of the second ethernet controller.
Set the network subnet mask for the first ethernet controller.
Set the network subnet mask for the second ethernet controller.
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)