Replacing A Lens; Remove Lens - Christie CP2000-M User Manual

5.6

Replacing a Lens

A variety of lenses can accommodate different throw distances and specific types of installations. For details,
refer to Section 7
lenses shown.

5.6.1 Remove Lens

1. Turn the projector OFF. Allow the fans to cool the lamp before unplugging the projector. If necessary, a
lens can be swapped out while the projector is running, but this can result in dust being drawn into the
projector. Avoid if possible.
2. Install the lens cap and release the lens clamp by pushing it up (Figure 5-4).
3. If necessary, remove the two cap screws securing the lens to the lens mount (Figure 5-4). The cap screws
are only needed when the projector is ceiling mounted.
4. Pull the lens out of the lens mount. The lens, motorized zoom and focus connectors disconnect when the
lens is pulled straight out of the mount.
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)
Specifications. To change a lens, follow the steps below. No tools are required for "compact"
Figure 5-3 Lens Assembly
Figure 5-4 Release Lens Clamp
Section 5: Maintenance
5-9