Admin: Network Menu; Summary Of Admin: Network Menu Options - Christie CP2000-M User Manual

Section 3: Operation

Admin: Network Menu

Use the Admin: Network menu to define or change the Ethernet settings—i.e., network address of the
projector. Record any new settings in Section 1.
A Management IP: Address specific to
SNMP network management system
B
SNMP Configuration: Enable or disable
SNMP network management system to
allow network administrator to manage
network performance
C
Ethernet Remote Access Control:
Restrict who can access the projector. No
Access, Login Required or Free Access
D
Device Group: Assign group name for
several related devices
E Device Name: Assign projector name

Summary of Admin: Network Menu Options

Identification
• Device Name: Assign a specific name for a device in the network.
• Device Group: Assign a name to a group of related devices on a network.
Ethernet Remove Access Control
• Level: Apply restrictions on who can access the projector remotely (using serial commands).
SNMP Configuration
• ON/OFF: Enable or disable the SNMP network management system to allow network administrators to
manage network performance.
• Management IP: This is a specific address related to SNMP Configuration, assigned by network
administrators.
• Apply (SNMP Configuration): Implement SNMP Configuration settings.
3-52
Figure 3-41 Admin: Network Menu
F IP Address: IP for projector location on net-
work - must be valid & unique for this device &
site
G
Net Mask: Defined by network administrator
H
Gateway: Site specific network address - use
the same address for Ethernet management &
Aux Ethernet ports
I
DLP IP: This must be set specific for theater.
Use the CDP or web UI to change it - do not
use DLP Control Application
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)