Projector Power States - Christie CP2000-M User Manual

2. At the CDP, press
DOWN mode where the fans and electronics remain on for 15 minutes. After this cool down period, the
projector enters STANDBY mode, and all fans and most electronics power down.
3. If servicing or removing any projector cover, disconnect AC.
4.

3.3.1 Projector Power States

Table 3.1 identifies what occurs when any of the CDP's Power and Lamp keys are selected during the
projector's four main power states. Also, refer to
Table 3.1 Projector Status when any CDP Lamp or Power Key Selected
Power ON To full power ON (boot delay)
Power OFF No action
To power ON and lamp ON
Lamp ON
(boot delay)
No action
Lamp OFF
The green status LED flashes while the yellow LED is on steady during "Boot Delay".
NOTES: 1)
ensure activation of the CDP Power or Lamp keys, press firmly for 1/2 second.
Fast Boot Mode
There are two ways to initiate fast boot mode:
1. When the projector boots up, the CDP shows the failsafe signal where all 3 LEDs flash 3 times. After
about 25 seconds, the greed LED labeled "ON" will flash 3 times. Push and hold the Power On button
while the ON LED is flashing turns both TI and the Lamp ON.
2. The projector saves the last power status in flash memory. If the power goes off while the projector is in
Full Power or Lamp ON mode, the software will automatically put the projector in Full Power mode when
it boots up again where everything is turned on except the lamp.
Fast boot mode can speed up about one minute of the projector startup time.
Fast Cool Mode
During cooling down mode, pressing the POWER OFF button 3 times will set the projector to standby mode.
This feature allows you to quickly shut down the projector. It is not recommended unless the projector needs to
be shut down immediately.
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)
. The lamp powers OFF first then the projector automatically enters a COOL
POWER OFF
Standby Power Mode Power ON / Lamp OFF
No action
Power OFF immediately
To lamp ON (immediately)
No action
Table 3.2 Status LEDs: Indicating Projector
Projector's Current State:
Power ON / Lamp ON
No action
To cool down mode, after
15 minutes goes into
STANDY mode.
No action
Lamp OFF (immediately)
Both green and yellow status LEDs flash during "Cool Down". 3) To
2)
Section 3: Operation
Status.
Cooling Down Mode
Once the projector has
cooled down it remains in
full power mode.
Once the projector has
cooled down it goes into
STANDY mode.
To lamp ON (immediately)
No action
3-5